塑胶场地基层处理
Plastic ground base treatment
1、试水：洒水测试场地平整，将地面凹陷超过3mm处用粉笔做记号。
1, to test the waters: sprinkler test site formation, the ground depression is more than 3mm, made with chalk mark.
2、补平：用掺40-70目石英砂、水泥和水
2, reinforcing: mixed with 40-70 mesh quartz sand, cement and water
塑胶场地刮涂层次
Plastic floor squeegee level
1、底层：用进口橡胶刮耙刮涂胶水
1, bottom: use imported rubber scraper rake blade coating glue
2、弹性层：用丙烯酸胶粒全场涂刮五层（3粗2细）
2, the elastic layer: use acrylic particles the scraping five layers (3 crude 2 fine)
3、加强层：涂刮一层以丙烯酸填充剂兑水掺60-80目石英砂4、纹理层：涂刮二层以丙烯酸色料兑水加 80-100目石英砂
3, strengthen layer: coating a layer of acrylic water mixed filler against 60-80 mesh quartz sand 4, texture layer: scraping two layer to acrylic pigment against the water added with 80-100 mesh quartz sand
5、终饰层：涂刮一层以丙烯酸色料兑水稀释
5, finishing layer: coating a layer of acrylic pigments diluted
6、划线：用刷子直接刷丙烯酸白线漆涂料一层。
6, marking: directly with the brush brush a layer of white paint of acrylic acid.