一、施工基础地面清扫干净，注意有没有不平的地方，补平不平的地方。
One, construction of the foundation of the ground clean, pay attention to the rough places, reinforcing the uneven place.
二、铺装一定要把地板对齐。需要 现场划线的要画好线。不需要划线的，对齐地板的对角线很重要。
Two, the pavement must take the floor alignment. Need to draw the line marking. Does not need to be crossed, diagonal alignment floor is very important.
三、粘地板要把两片地板连在一起。使用铝箔胶带，尽量减少对基层地面破坏。
Three, stick a floor to two floor together. The use of aluminum foil tape, try to reduce the damage to the ground.
四、开槽时一定要注意不能把槽开大了或者开深了，如果开深了可能会造成焊线不匀，或者根本焊不住。
Four, must be careful not to slot slot open big or deep, if open deep may cause welding line is not uniform, or simply welding not to live.
五、焊线时要注意速度不能过快，要匀速，如果快的话焊线就焊不住了。最后要把多余的焊线用抢刀去掉。
Five, welding line should pay attention to when the speed is not too fast, should be uniform, if fast enough welding line welding not to live. Finally, to get a knife to remove excess welding line.